Thingiverse
Rock64 Case
door Johncollier
18
Downloads
6
Likes
0
Makes
This is a tweak on the Rock64 case referenced. I needed to put an 1/8" jack for GPIO pins on the top of the case, so I stretched the top higher and put the hole in the correct place.
i also cleaned up the holes and made them fit the M2.5x20mm sockethead screws I had.
i also cleaned up the holes and made them fit the M2.5x20mm sockethead screws I had.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!