Rocket lift up

Hello there,

i printed this 42.5cm tall beauty from g-create! This is the original thing: 427789

https://www.thingiverse.com/thing:427789

Fix:
- i fixed the bottom so its flat now
- made the smoke in lower resolution so it looks like a bit low poly
_______________________________________________________________

- Printed the Ropcket with Supports (only from Buildplate)
- infill is just 10% @ 0.2mm Layerhight

Rocket: PLA Filamentum Vertigo Grey
Smoke: PET-G
Flame: PLA Filamentum Orange
__________________________________________________________

- i use teflon tape instead of glue to assemble the parts together