Slicer Discord
Rod Hinges (Geometry) – 3D-Druckmodell von Thingiverse Thingiverse

Rod Hinges (Geometry)

von kwkosko
1 Downloads
0 Likes
0 Makes
Zum Modell
These "rod hinges" allow you to take Cuisenaire Rods, or other centimeter-based length rods, and use them to create geometric shapes.

The square cup to hold the rods are .25mm wider and higher, which allows for a snug enough fit but also for you to remove the rods easily. Hinges are printed in place. I made this so that you can create 10 at a time (good for small groups or pairs to use with rods to make shapes).

Edit: I added a 2nd version of the hinges with a slightly wider opening. This is useful for 3D printed rods that may be a few hundredths of a cm larger than molded plastic rods.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

kwkosko veröffentlicht auch auf

6 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen