Thingiverse
Rod holder using map pin
von suzuking
9
Downloads
2
Likes
0
Makes
It is a rod holder that utilizes a map pin.
Because it can be attached to the wall without using nails,
It does not leave marks on the wall, so it is recommended for rental housing.
The point is that there is a hole so that the map pin can be inserted diagonally downward at 30 degrees.
It won't come off easily even if you hang something heavy on it.
*Map pin (needle length of 10mm or more recommended)
*Please use at your own risk.
Because it can be attached to the wall without using nails,
It does not leave marks on the wall, so it is recommended for rental housing.
The point is that there is a hole so that the map pin can be inserted diagonally downward at 30 degrees.
It won't come off easily even if you hang something heavy on it.
*Map pin (needle length of 10mm or more recommended)
*Please use at your own risk.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
