RØDE Wireless Micro Microphone Case

A case to store the RØDE Micro Microphone together with the acessories. I recently purchased the RØDE Mics and found that the charging case stores only the Mics and the USB reciever, but not the wind muffs or the charging cable. So I made this to allow storage. I created this case to store all of the parts together I added the TPU interior for additional protection. Im sure printing it in another material would still be better than letting it rattle around. Currently the profile has the TPU with not walls or top surface, its infill only. But walls can be added and the infil reduced as desired. You will need 6, M3 X 25mm screws to complete the case. Im sure there are printable pins to do the same, but I havent tested these. The case also includes a TPU filament seal for additional protection. Probably not waterproof, but better than nothing. Just take a legnth of TPU filament and use a little glue to kjoin the ends and keep it in place. Boost MePlease consider a Boost if you benefit fro