ROG phone 6 case

perfect fit phone case for ROG phone 6. there are 3 different models.each profile is actually a different model.one piece blank back with no hole.2 part case with the PopSocket mount system.1 piece with a circle cut-out and a “the thinker” (Rodin) design meant for 2 colors. for that last model:the circle cut-out is meant for a back ring or stand thingy. so that it sticks out less.no AMS required.make sure the pauses are correctly set on layer 0 and 8 of the case body and that z-hop ≥0.4mm is enabled.print thinker inlay in filament 1.start case print, during the pause swap to filament 2.when it pauses again swap to TPU, !!!MAKE SURE TO FORCE NOZZEL TEMP TO 240 FOR TPU TO BOND!!!you could do it all in PLA if you don't take it in and out of the case many times it won't flex enough to crack. but if you do this change the material settings and re-slice, TPU prints much slower.PS: the yellow wasn't a really a choice, it's the only TPU roll I had.