ROKFORM Easy Removal Plug (for wireless charging ease)

A remix of @Wadoman1's RokForm Phone Case Clip. I wanted a plug that would fill the rear of my new RokForm case, but wouldn't require removal of the phone in order to insert it. Most importantly, it needed to be plastic, because the included plug that they give you has a very strong magnet that prohibits wireless charging. A drastic oversight of this design was that once the plug is turned and locked in place, the tabs move out of the way of the hole and still leaves some of your phone exposed. However if you're ok with only having 90% of the hole plugged, then this print will work just fine for you. Overall height once inserted is just shy of the overall thickness of the case, so it wont wobble or interfere with charging wirelessly. If this post gets any attention I might consider designing a full plug that works the same as the included one, just minus the magnet. Feel free to remix and post your makes! I'd love to see if my effort of re-learning fusion360 just for a little piece of