Thingiverse
Music
Go to Model
Roland TR-8S Stand
21
Downloads
28
Likes
0
Makes
This stand can be used to bring a Roland TR-8S into a more ergonomic setup. It's angled at 15 degress.
The STL only contains the left side. For the right side just mirror the stand.
If you have to print it in two pieces I recommend slicing it through the middle vertical strut.
For the horizontal bars any bar with a 6mm diameter should suffice. I used brass bars in this build.
Cut them to a length of 390 millimeters for a perfect fit.
In my print I had to use a 6mm drill to make the holes a bit wider.
Now the bars fit in so perfectly that they don't even need to be glued in to be solid.
The STL only contains the left side. For the right side just mirror the stand.
If you have to print it in two pieces I recommend slicing it through the middle vertical strut.
For the horizontal bars any bar with a 6mm diameter should suffice. I used brass bars in this build.
Cut them to a length of 390 millimeters for a perfect fit.
In my print I had to use a 6mm drill to make the holes a bit wider.
Now the bars fit in so perfectly that they don't even need to be glued in to be solid.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
