Rolex Logo Watch Stand

Simple Rolex logo watch stand. For assembly I glued the stand to the logo, due to the nature of the logo could not make the extrude deeper without making a through hole. Printed on A1 Mini, standard 15% infill for both, tree support for the stand.I have included various sizes of the stand to support different wrist sizes. Only the top is scaled, the stem is the same for all of them. For my almost 7 inch wrist I am using the 95% scaled version but have applied a piece of faux leather tape on the surface (link below). Without the tape should use 98 percent for a near 7 inch wrist. I have made some other brands too. Let me know if you would like one. https://www.amazon.ca/dp/B0D2XQRBMM?ref=ppx_yo2ov_dt_b_fed_asin_title