Roll Support for Spools - Ender 3 - V2

Version 2 (V2)

I made a smaller version, so now it fits smaller spool holder holes.
It fits as low as a internal spool holder diameter of 56mm

If you like my designs, please support me. Even $1 is fine :) paypal.me/bmabma

---------------------------------------------


The original spool holder of Creality Ender 3 has a diameter (30mm) too small in comparison to the spools i've been using (74mm) so I did this support.

There are 2 supports that are clamped to the original spool holder, and each one has 2 rolls on the top that make contact with the spool. No need to use bearings, bolts nor any extra part, just print it!

I used 0.2mm of layer height, 0.20 infill and tree supports


You need to print:

- 2x Roll support for spools - Ender 3 - CLAMP
- 4x Roll support for spools - Ender 3 - ROLL