Thingiverse
Rollerblade c4
von iwan18
0
Downloads
0
Likes
0
Makes
inspired by chasgiv4's previous posts .www.thingiverse.com/thing:3784230
.and I like the design. and I made a lot of changes at some point. the middle point of the filament was very accurate. so that the filament is very easy to enter. springs used 8mm to 10mm.Bearing problems can be overcome here. with a very accurate bearing cap. so the bearing cradle is strong and not tilted.
sorry my english is bad
.and I like the design. and I made a lot of changes at some point. the middle point of the filament was very accurate. so that the filament is very easy to enter. springs used 8mm to 10mm.Bearing problems can be overcome here. with a very accurate bearing cap. so the bearing cradle is strong and not tilted.
sorry my english is bad
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
