Thingiverse
Rolling Log Mouse Trap Parts
door SmilingImpact
234
Downloads
176
Likes
0
Makes
These are parts used to build a rolling log mouse trap with no drilling. The idea is after you catch all your mice (live or otherwise) you can easily remove the log mechanism and use the bucket again like new.
For an identical setup to the picture you will need:
-1 PVC pipe 0.840 inch (21.3mm) diameter cut to fit.
-2 608 skate style bearings also used for fidget spinners.
-1 5 Gallon Bucket
-Bait
For further information on the rolling log mouse trap see: http://www.thesurvivalgardener.com/best-mouse-trap/
The Parts layout is as follows:
-The hollow cylinder joins the pvc and bearing.
-The other two pieces fit together (match the tabs to the slots) and then are inserted into the center of each bearing.
The Log mechanism is now complete and can be installed atop a 5 gallon bucket.
Add bait and ramps to complete the trap.
For an identical setup to the picture you will need:
-1 PVC pipe 0.840 inch (21.3mm) diameter cut to fit.
-2 608 skate style bearings also used for fidget spinners.
-1 5 Gallon Bucket
-Bait
For further information on the rolling log mouse trap see: http://www.thesurvivalgardener.com/best-mouse-trap/
The Parts layout is as follows:
-The hollow cylinder joins the pvc and bearing.
-The other two pieces fit together (match the tabs to the slots) and then are inserted into the center of each bearing.
The Log mechanism is now complete and can be installed atop a 5 gallon bucket.
Add bait and ramps to complete the trap.
SmilingImpact publiceert ook op
43 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
