Thingiverse

Rolling Spool Holder Holder

von orneryd

64 Downloads

58 Likes

1 Makes

I printed off 2x spool holders from https://www.thingiverse.com/thing:2086877 and designed the large base to be 50mm center to center which works for my spools (AMZ3D & Hatchbox). you can use the single if you want for wider or narrower spools.

after placing the bearing between two holders just slot them right into place, they should fit snugly and secure

608 bearing filament filament-spool filament holder filament spool filament spool holder low friction 608 bearing filament filament-spool filament holder filament spool filament spool holder low friction 608 bearing filament filament-spool filament holder filament spool filament spool holder low friction 608 bearing filament filament-spool filament holder filament spool filament spool holder low friction

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat