Rolling tray to go

Designed this rolling tray to go. it is very simple to print and it sure is functional. It can hold the herbs or whatever you are using it for without spilling it out. It is compactly sized and quite robust.

You should just take care that the first layer of the flexible part is printet close to the (glass) bed, so you dont get much print lines, which would trap your kief or small particles.

When you put the tray together, you take sharp knife and cut the flexible part (be carefull not to go too deep) where the halves meet, so that your tray can be closed.

It all should hold together fine without using any glue or anything, but it can be used if the fit is not right for your printer.

Also, you have to orientate the parts diffrently. You need to print two "frames of the rolling tray" and one "rolling tray" from tpu or other flexible material.