RollUp Mount Replacement Part

SummaryNeed:1 M3 16mm1 M3 nut1 M4 washer The screw only serves as a support for the plastic so that it does not break so easily due to layer alignment. Cap (3) then closes the hole as a lid.Hopefully you can see in the photos how it is intended. Cap needs a bit of force, I closed it with a small clamp.I have printed everything in PLA.Parts:0 mirro of 1 mirro keypart3 is cap4 is dual mount5 mirro of 6 single mountDual MountI split the bracket that has a holder on two sides in the middle and then pressed it with dowels in slicer is not ideal but it works.