Thingiverse
Roomba Bumper
by Magnatic
15
Downloads
9
Likes
0
Makes
Does you Roomba get stuck on low ridges? With this bumper you lower the standard bumper to about 1cm.
To install, just unscrew the bottom of the bumper, place this print and fasten with the same screws.
No supports needed, layer height 0.3mm
To install, just unscrew the bottom of the bumper, place this print and fasten with the same screws.
No supports needed, layer height 0.3mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!