Roomba Charger Command Strip Bracket

Roomba Charger Command Strip Bracket

This bracket fits on a Roomba charger and is just large enough for 2-3 medium sized 3M command strips to hold it against the wall or baseboard.

It's probably a little thicker than it needs to be, but my previous print broke, so I wasn't taking any chances. This one has held up for 3 months no with no obvious signs of wear.

This is small enough to fit on a 12x12 print bed, if you rotate it 45 degrees and keep the skirt or brim to about 1mm. Note that it's designed upside-down, which is how it should be printed.