Root 3 Lite DXF with drill marks

UPDATE:

Due to request, I've added a printable PDF file with height reference.

___

UPDATE:

I finally found time to setup my laser and engrave the DXF onto a test piece. I used a 4 / 9 mm drillbit and 20 / 25 mm forstner bits to drill the holes. The outer perimeter was cut on my bandsaw. Havent checked the fitting yet, but it looks alright.

____

This is a DXF file (to scale) of the X gantry side panel for the Root3Lite (dated 25.12.2017).

Comes with drill markings if you want to fabricate it by hand.

Note that this file is currently untested - I will try to replicate it on my laser engraver after the holidays.