Thingiverse
Rope Cleat
door benson_dunwoody
4
Downloads
0
Likes
0
Makes
Each part prints with the flat side down.
After printing insert an M4 brass hot-melt insert (4x6x7mm) into each hole in the bottom part. Use 3mm ish screws with 6-8mm flat head to fasten the bottom part wherever you want the cleat mounted. Then secure the top part to the bottom part using two 25mm long M4 screws.
After printing insert an M4 brass hot-melt insert (4x6x7mm) into each hole in the bottom part. Use 3mm ish screws with 6-8mm flat head to fasten the bottom part wherever you want the cleat mounted. Then secure the top part to the bottom part using two 25mm long M4 screws.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
