Thingiverse
Rope Clip
von adamkempenich
40
Downloads
23
Likes
0
Makes
These are designed to have a knotted rope permanently attached on the back side of them, which gets run around a bar (or whatever you need to tie down), and then through the hole in the bottom, with the teeth holding the rope in place.
The rope used is cotton-thread 3/8". We use these to do everything from cinching up coffee bags, to holding down film gear and bounce boards.
*DISCLAIMER* Don't use this for climbing or anything life threatening. It will break and I don't want anything bad to happen to anyone :)
The rope used is cotton-thread 3/8". We use these to do everything from cinching up coffee bags, to holding down film gear and bounce boards.
*DISCLAIMER* Don't use this for climbing or anything life threatening. It will break and I don't want anything bad to happen to anyone :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!