Thingiverse
Rope Guide Eyelet Wall Mount
von ceazzy
16
Downloads
11
Likes
0
Makes
Designed this so that I could have something to feed my rope vines through in my chameleon cage. I did NOT design this to handle large loads of force.
The hole is designed for a 3/4 inch sheet metal screw.
Here's my recommended settings
Infill: >30%
Layer Height: 0.20-0.26
Outer Wall Count: 3
No Supports (print with the eyelet flat on the print bed)
The hole is designed for a 3/4 inch sheet metal screw.
Here's my recommended settings
Infill: >30%
Layer Height: 0.20-0.26
Outer Wall Count: 3
No Supports (print with the eyelet flat on the print bed)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
