Rotary Phone Clock

This is a simple model of an old wall hanging Rotary Phone converted into a clock!Comes complete with a 3D printed phone cord and detached handset. However, while the phone cord does stretch a bit (I just used PLA), it is not 100% flexible like old phone cords used to be! My model was printed using 100% PLA, supports are needed for the phone base and cord.Be VERY careful when removing the supports from the phone cord as I went through several revisions and wasted prints before I arrived at the cord included with this model! The Clock Face does require some super glue if you wish to attach the (red) dial stopper to add this little rotary phone detail.I tried to print this with support, but it ended up being too difficult to remove as I really wanted it to float above the clock numbers.When assembling this part from the Bambu Labs clock kit, I did place the rubber washer between the phone base and clock face to help keep the clock face from spinning around too much. The washer and nut we