MakerWorld
Engineering
Go to Model
Rotating Mechanism #3
43
Downloads
30
Likes
15
Makes
Hey Everyone!OK, so I seem to have a new obsession with these rotating mechanism's. This one is called “The Gatling” (Hobson Joint) for obvious reasons. I hope you enjoy these interesting movements as much as I do drafting them! Dimensions:150mm Sq. x 85mm H Print Specifications:PLA0.4 mm nozzle0.2 mm layer height2 wall loops15% infillminimal support Instructions:You will need to print Plate 1 (link set 1) twice for a total of 10 link bars. Be sure the square drive hole on the barrels is facing out when inserting bars and the axle stands are in the pictured orientation. Assemble the barrels, axles and stands before gluing to base.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
