RotorX Atom v2 - GoPro Session Mount

Designed a mount to attach my GoPro Session to the Atom v2. This includes both a framed mount and an unframed mount. The unframed mount will work on the session with or without a case and should support other cameras as well.

Print with supports.

Mount by using the back two canopy screws and a drilled hole in the front for an additional screw. I placed foam 3M tape under the mount to help with vibrations.

I found it best to remove the canopy push the back two screws through the holes in the canopy, then hold the canopy up to the light and mark the front hole from the inside of the frame. then drill the whole from the inside and install the m3 screw. I choose the second hole from the front but any of the holes will work.

Post up photos if you print!