Thingiverse
round seed raising pot
di sozman
6
Download
2
Likes
0
Makes
# Seed raising pot
I wanted something that I could pack in trays but allows a bit more room for seeds to grow before potting.
some features I wanted:
- taller than typical seed raising modules you find in the gardening section. More room for roots and I can add water to tray without drowning them.
- straight sides - more room for roots.
- big hole in the bottom to make it easier to push the whole wad out in one piece.
- easy to print - vase mode makes it pretty quick to print and you can up the speed easily
Printed in vase mode - ie very thin but you should get a few uses out of it but is possible to cut if you need to liberate a stuck seedling.
I use PLA for mine but if they are going in hot sun, especially behind glass then they will deform.
I wanted something that I could pack in trays but allows a bit more room for seeds to grow before potting.
some features I wanted:
- taller than typical seed raising modules you find in the gardening section. More room for roots and I can add water to tray without drowning them.
- straight sides - more room for roots.
- big hole in the bottom to make it easier to push the whole wad out in one piece.
- easy to print - vase mode makes it pretty quick to print and you can up the speed easily
Printed in vase mode - ie very thin but you should get a few uses out of it but is possible to cut if you need to liberate a stuck seedling.
I use PLA for mine but if they are going in hot sun, especially behind glass then they will deform.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
