Thingiverse
RP1 rx holder
por madkwad
8
Descargas
8
Likes
0
Makes
RP1 rx holder for a 20x20 mount.
The receiver is tightened with a zip tie that passes through the two notches.
Additionally, there is a hole through the support to allow for the passage of an antenna wire.
The receiver is tightened with a zip tie that passes through the two notches.
Additionally, there is a hole through the support to allow for the passage of an antenna wire.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
