Thingiverse
RPi HQ Camera Mount
von wallyware
11
Downloads
12
Likes
0
Makes
A simple 1.5mm flat plate that allows the HQ camera to mointed the backside of a Raspberry Pi. In addition to this print you will need:
1) Eight M2.5 6mm screws
2) Eight M2.5 8mm threaded spacers
My part was made without supports using PLA and a 0.2mm layers
1) Eight M2.5 6mm screws
2) Eight M2.5 8mm threaded spacers
My part was made without supports using PLA and a 0.2mm layers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!