RSA token holders and stand

As a system administrator with multiple accounts on multiple networks, I needed an RSA holder for all 6 of my tokens. The problem was the most I've seen was one that holds 3 or integrated into a badge holder. I also wanted a stand to make it easy to read the codes. I found the Dual RSA Token Holder on Thingiverse and adapted it to my needs and built the stand entirely inside Orcaslicer. I added a little notch on the stand so the round end of the token fits better and the holder doesn't slide off. As long as you have tokens back-to-back, they fit very snug and will not slip out. Single tokens do not fit properly. Maybe I'll try to add a single holder on the top at some point. Prints well in both PLA and PETG