RTS Rocket

I've had a blast designing this helicopter blade spinning assembly that deploys when your Motor ejection charge blasts. Using rubber bands to snap open the blades, they will spin and (hopefully) slow your rockets descent. I also make use of a small drogue chute (9" Estest) which is very undersized on its own for a rocket this heavy but along with the spinning rotor, i've recovered this rocket from launching multiple times. It uses a BT-70 body tube and can fit E and D sized motors (24mm). You will need some M3 screws (4 of them) at either 16 or 18mm along with 4 M3 nuts and the rest can be printed. i've attached a PDF with detailed instructions

Parachute: https://www.amazon.com/Estes-2268-9-Inch-Printed-Parachute/dp/B00TKBM50I
M3 Screws: https://www.amazon.com/gp/product/B07VNDFYNQ
Aluminum Tubing (Optional): https://www.amazon.com/uxcell-Seamless-Aluminum-Straight-Tubing/dp/B07WLN69T1
BT-70 Tube: https://www.apogeerockets.com/Building_Supplies/Body_Tubes/Low_Power_Tu