Rubik's Cube Core Pegs

Print these flat, NOT vertical. The point of the halves is to give the pegs tension strength.

This is a two piece peg designed to hold together the components of a rubik's cube core. You will need two halves per peg. The washer holds the two halves together and provides a smooth surface to reduce spinning friction/catching.

There is a short and long version of the peg. You may need to trim the length after printing depending on the core you are using. I used short pegs for five sides, and a trimmed long for the sixth side to allow easier assembly.

The pegs can be glued into the core, or in my case they were a pressure fit.