Ruger 10/22 suppressor MK3

Fits the Ruger 10/22 standard barrel.
Slips and twist around the front sight.

Warning!
I have not testet this design yet.
Needs support, but check that your slicer does not fill the internals!

Printet with 8 walls and 100% infill but can probaly work with less.
Requires a short spring with a inner diameter of minimum 9mm and outer diameter of about 10mm to use with the inkluded washer.
Also needs a short screw to stop the suppressor from missalign with the barrel (may work without).

I have also included a cutaway of the model.