Thingiverse
Rugged LoRa T beam communicator case
di turboprint3D
25
Download
18
Likes
1
Makes
I wanted a simpler to make rugged case for my tbeam LoRa based communicator network , than was available. I also wanted added support for the antenna , with this design it is clamped into the case with the gasket ,witch should help in the case of rough use cases . The buttons are also slightly recessed so that it is unlikely to accidentally press one of them. the buttons are also protected behind the tpu membrane . there is also a loop on one end that fits a small carbine or cord .
the case is 3 pieces top , gasket and bottom.
the gasket needs to be out of tpu , and helps keep dust and water out of the case and off of the electronics .
hardware
4pc m2 x 5-6mm screws ( the ones that come with 9g servos)
4pc m3 x 20mm machine screws ( cap screws whatever you want stainless is preferred)
OR 4 pc m3x 24mm machine screws
4 pc m3 nuts ( this is not required but can be done for exta piece of mind )
I printed mine from petg
the case is 3 pieces top , gasket and bottom.
the gasket needs to be out of tpu , and helps keep dust and water out of the case and off of the electronics .
hardware
4pc m2 x 5-6mm screws ( the ones that come with 9g servos)
4pc m3 x 20mm machine screws ( cap screws whatever you want stainless is preferred)
OR 4 pc m3x 24mm machine screws
4 pc m3 nuts ( this is not required but can be done for exta piece of mind )
I printed mine from petg
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
