Thingiverse
Ruler Marking Gauge
von danny243
89
Downloads
56
Likes
2
Makes
Mario Zimmermann's ruler stop did not fit my steel rulers. So I created a design that suited me.
The size of the steel ruler can be adjusted in the OpenSCAD file. Please add about two tenths to the width and height so that the ruler can move freely.
As in the original design, you will need an M3 screw with a length of 25-30 mm (depending on the width of the ruler) and a suitable square or hexagonal nut.
The size of the steel ruler can be adjusted in the OpenSCAD file. Please add about two tenths to the width and height so that the ruler can move freely.
As in the original design, you will need an M3 screw with a length of 25-30 mm (depending on the width of the ruler) and a suitable square or hexagonal nut.
danny243 veröffentlicht auch auf
5 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
