Thingiverse
Ruler stand
von boredzo
18
Downloads
10
Likes
0
Makes
*Ruler not included.
This is an upright stand for a ruler or similar-shaped object. The initial configuration fits a 1-inch-wide, 1-foot-long wooden straight-edge ruler, such as you can get at Target for less than a buck. You can Customize it to change the settings to fit differently-sized rulers.
The ruler leans back at an angle of five degrees. This, too, you can change.
This is an upright stand for a ruler or similar-shaped object. The initial configuration fits a 1-inch-wide, 1-foot-long wooden straight-edge ruler, such as you can get at Target for less than a buck. You can Customize it to change the settings to fit differently-sized rulers.
The ruler leans back at an angle of five degrees. This, too, you can change.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!