Thingiverse
RUMBA output test gcode
von kharar
94
Downloads
62
Likes
0
Makes
Rumba output test gcode
Turns on FAN0, FAN1, HB, HE0, HE1 & HE2 for one second. Output led's should blink.
Then it will sequentially run all motors in one direction, then the other.
During this test, acceleration and steps per mm are changed for all motors so make sure to reset your printer after executing this file.
Turns on FAN0, FAN1, HB, HE0, HE1 & HE2 for one second. Output led's should blink.
Then it will sequentially run all motors in one direction, then the other.
During this test, acceleration and steps per mm are changed for all motors so make sure to reset your printer after executing this file.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
