Thingiverse
Runcam 2 Lens Cap
by TooTomThumb
8
Downloads
2
Likes
0
Makes
Runcam 2 lens cap printed in ABS and gives a satisfying "click" when it is snapped in place. If anything the tolerances may be a bit tight so it can be quite tough to get off again!
It only weighs 2 grams so print at 100% infill. More than likely it doesn't matter because no wall is more than a few millimeters thick and it will be 100% infilled already.
It only weighs 2 grams so print at 100% infill. More than likely it doesn't matter because no wall is more than a few millimeters thick and it will be 100% infilled already.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
