Thingiverse
RunCam Swift BackPlate Replacement
por beta_ready
43
Descargas
34
Likes
0
Makes
This is an aftermarket back-plate that I designed for use with the RunCam Swift after breaking a few too many of the housings and getting tired of paying for new ones. It works with the original bracket, you just need some M3 hardware (which you should have sitting around as it's used on most quadcopter frames). It takes two sets of M3 nuts and bolts and you'll need to loosen up the bracket slightly with a file on the slide.
Print it strong with high infill in ABS - don't worry about supports, it prints fine without them.
I've had it on my main quadcopter for about a month now and it has survived about a dozen crashes so far - one or two of them being fairly spectacular - so I'm happy to release it into the world now.
A few words on the design and process in the video at the following location: https://youtu.be/CNIZhfPRnwo
Print it strong with high infill in ABS - don't worry about supports, it prints fine without them.
I've had it on my main quadcopter for about a month now and it has survived about a dozen crashes so far - one or two of them being fairly spectacular - so I'm happy to release it into the world now.
A few words on the design and process in the video at the following location: https://youtu.be/CNIZhfPRnwo
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
