Thingiverse
RunCam3 Protective Cover
von glef
44
Downloads
49
Likes
1
Makes
Protective cover for RunCam 3 with brackets for simple strap or zip ties attachment.
Very Snug fit.
This was built to hold the RC3 on the Armattan Chameleon and Japalura frames, but it certainly can be used for other frames.
Feel free to modify it and add some angle mount to it if you want to use this on a flat frame.
The print will not work with any rigid filaments. Print in TPU or Cheetah with support. (Haven't tried without)
09/09/2017 - Added a new V2 version that is fully symmetrical with straps anchors all around the frame. Anchors are also thicker for added resilience and a few grams were also saved in the process.. :)
enjoy.
g
Very Snug fit.
This was built to hold the RC3 on the Armattan Chameleon and Japalura frames, but it certainly can be used for other frames.
Feel free to modify it and add some angle mount to it if you want to use this on a flat frame.
The print will not work with any rigid filaments. Print in TPU or Cheetah with support. (Haven't tried without)
09/09/2017 - Added a new V2 version that is fully symmetrical with straps anchors all around the frame. Anchors are also thicker for added resilience and a few grams were also saved in the process.. :)
enjoy.
g
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
