Thingiverse
Runout filament optic sensor case
von cacalot93
6
Downloads
3
Likes
0
Makes
After major modification from Bowden to Direct drive on my Ender 3 V2. I just want to keep filament running through the PTFE tube from the dry box to the extruder to avoid moisture that came from raining frequently in my area.
Hardware needed:
PC4 M6 x 2 Pneumatic Bowden.
(Optical Endstop Limit Switch Sensor 3 pin + cable 70CM long) x 1.
Short PTFE Tube
Hardware needed:
PC4 M6 x 2 Pneumatic Bowden.
(Optical Endstop Limit Switch Sensor 3 pin + cable 70CM long) x 1.
Short PTFE Tube
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
