Thingiverse
Runout sensor
von Rotorbugjl
41
Downloads
25
Likes
0
Makes
Filament Runout sensor/switch.
This is designed for a 19mm x 6mm micro switch.
The one i used did not have the curved tip on the lever.
But it works a charm, you might need to curve the lever a bit or shorten it as needed.
Print 2 units.
One normal and one Mirrored.
Assemble and use.
This is designed for a 19mm x 6mm micro switch.
The one i used did not have the curved tip on the lever.
But it works a charm, you might need to curve the lever a bit or shorten it as needed.
Print 2 units.
One normal and one Mirrored.
Assemble and use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!