Thingiverse
Rust Logo with Text and Stand V2
by ThattCatto
61
Downloads
50
Likes
0
Makes
I'm back again with another design for Rust this time i have made the rust stand a bit more friendly to put together by adding finger joints so that no glue is required when assembling it.
I have added a 0.2mm offset to the base finger joint so that when printed it will need only a small amount of cleaning up for it to function in the correct manner.
The base is 250mm in length so it may not be able to printed on some printers however i might change this by adding a base that has been split in half and can be joined via a dovetail joint.
**Just comment if you would like the addition sooner rather than later.**
I have added a 0.2mm offset to the base finger joint so that when printed it will need only a small amount of cleaning up for it to function in the correct manner.
The base is 250mm in length so it may not be able to printed on some printers however i might change this by adding a base that has been split in half and can be joined via a dovetail joint.
**Just comment if you would like the addition sooner rather than later.**
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
