Slicer Discord
RV Lock Swing Arm – 3D-Druckmodell von Thingiverse Thingiverse

RV Lock Swing Arm

von RBDiggins
11 Downloads
4 Likes
0 Makes
Zum Modell
I lost one of the Hood latches on my MotorHome. They are very common and are used on most mailboxes. But there seems to be an infinite number of sizes. I could not find any that worked.

Also could be used for almost all RV Compartment Locks.

I drew this up and installed it on both sides of my MotorHome. (Just so it would look the same.)

Because it had to be strong I made it thicker and the original. So I used a longer bolt. Available anywhere. I got a few at Home Depot.

They fit perfectly and seem to be very strong.

Just another example of... If you can't find the right part, Print one out !
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen