Slicer Discord
RV Pipe Vent 1.5"  – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

RV Pipe Vent 1.5"

von Dr. Dan · Vehicles
3 Downloads
5 Likes
0 Makes
Zum Modell
I needed a unique fitting for a vent under the shower on my Class B Van conversion. If you look at the installed picture you will see the “P” trap just to the right of the vent fitting. I wanted to get as close to the bottom of the van floor as I could so the vent holes are facing up and have about ¼" clearance to draw air. The fitting fits into a 1-½" tubing as shown.
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

3 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen