Thingiverse
Ryan King Pumpkin
di mcavoya
3
Download
5
Likes
0
Makes
I created this little pumpkin in Blender by following Ryan King Art's [Stylized Hand Painted Pumpkins](https://www.youtube.com/watch?v=CfmJdZXt3O0) video. Ryan did an excellent job creating this tutorial, I am fairly new to Blender and I was able to follow along no problem.
I printed my pumpkin with supports sitting flat on his bottom. Turns out, this is not the best orientation. It left a rough area around the bottom, which isn't a big deal because you don't see it. But it also left a flat ring near the top, which you can clearly see in the photo.
I still recommend using supports, but with the pumpkin tilted back a few degrees. Not so far that you need supports on the stem, about 30 degrees will do. Also, consider adding a 5 mm brim to support the second layer, which may have unsupported loops depending on orientation.
The .bgcode file includes the above settings as shown in the screenshot.
I printed my pumpkin with supports sitting flat on his bottom. Turns out, this is not the best orientation. It left a rough area around the bottom, which isn't a big deal because you don't see it. But it also left a flat ring near the top, which you can clearly see in the photo.
I still recommend using supports, but with the pumpkin tilted back a few degrees. Not so far that you need supports on the stem, about 30 degrees will do. Also, consider adding a 5 mm brim to support the second layer, which may have unsupported loops depending on orientation.
The .bgcode file includes the above settings as shown in the screenshot.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
