Ryobi Battery Cap - Remix

New/Updated Design, v2 ... Link below
https://www.thingiverse.com/thing:5532499

(Updated with battery contact part numbers/link at end)

This is a modified version of the Battery power supply cap (https://www.thingiverse.com/thing:2782352).

I found this after starting my own battery cap, and instead modified this one. I edited the model to enlarge the area for the metal clips. I found that they did not quite align when I printed. They are now extra large and allow some room to move them forward or backward to adjust fit.

To get the correct fit, I had to scale up the piece, and ended up using an asymmetric scale to get the fit just the way I wanted it (metal progs are firm but not fully compressed, front to back is close but not over tight). All directions were 105% except the width (clip to clip) which was 105.5% to give a bit more space between the clips. Referencing the rounded end as the front, final measured dimensions are:
-- Inside side to side - 28.1mm (meas