MakerWorld
Other Tools
Go to Model
Ryobi Impact Driving Kit - Multiboard
31
Downloads
17
Likes
16
Makes
I found the original model after wanting to mount my own bit set. The original was great but made for the ryobi wall system. I only needed one slot and use the multiboard system, so I modified it to make it compatible. The front wall was also removed for easier access, as pulling up would pull it off the board. Pulling up also meant I needed way more clearance above than I'd like. Two multiconnect points are needed for this, I've attached my recommended model below for ease of use. Enjoy!
IsleTech also publishes on
56 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
