Ryobi Lantern Handle Holder

Designed this Ryobi One+ Lantern holder (model P781) so that it had a proper carrying handle. Didn't want to pull out the existing pin and replace the stock hook like a few others on here so this just fits directly into the existing hook. Has a little divot at the top if you want to hook it on a nail or tie it on a line. Fits a hand comfortably and makes carrying the lantern while camping or around the shop much nicer.

Should be printed with supports for the center part. You'll need to insert it into the hook on the lantern at an angle and it should be a little tight putting it on (to keep it from falling out later) but be somewhat loose once in there.

Printed it with an Ender 3 v2 with PLA at Standard Resolution (0.2) in Cura with 4 layer top, bottom and sides at 15% Gyroid infill. Simple print really.

With the hook this handle has some wiggle room but doesn't fall out and it makes it so much easier to walk around with that a handle is a must print if you own and use the Ryob