S8 Active Lanyard mount

Seems Samsung missed a key part of being Active, not dropping your phone in the first place. Ment to replace the bottom bumper of your phone. A T7 torx is need. I would recommend a little bit of flexible glue (not super glue!) between the lanyard loop and phone. Printed at 100% infill and 0.1mm layer height in PLA and very happy with it. Tie a approximately 6-7" loop in some small cord (I used 1.18mm micro cord) and push the end of the loop through the hole and then put the phone through the loop of cord and pull the opposite end tight, this will form a Larks head. Enjoy!