Thingiverse
Safari Class
di Tuaththua
90
Download
60
Likes
0
Makes
Safari Class Starship from the Traveller RPG model is Approx 150mm in length, STL will print successfully on a 0.3mm resolution printer.
A second file is available for the ships boat which slots between the landing legs.
To match the original design intent... there should be two antennae projecting to the rear. Carefully drill out the ens of the two prongs on the model.... purchase two long sowing needles use wire clips to cut off the thread-loops. superglue the sowing needles into the holes you have drilled.
Design based on illustrations copyright to Far Furture Enterprises
A second file is available for the ships boat which slots between the landing legs.
To match the original design intent... there should be two antennae projecting to the rear. Carefully drill out the ens of the two prongs on the model.... purchase two long sowing needles use wire clips to cut off the thread-loops. superglue the sowing needles into the holes you have drilled.
Design based on illustrations copyright to Far Furture Enterprises
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
