Thingiverse
Safety Razor Cap - Oceonics model
by Arne_h
7
Downloads
3
Likes
0
Makes
A 'safety' cap for a safety razor. Designed specifically for the 'Oceonics' safety razor.
Measurements are approximately:
Length: 43mm
Width: 25mm
Height: 9.7mm
Can be printed without supports.
Wall thickness (1.6mm) is made so it can be printed with a line width of 0.4mm. This way you should be able to print it without any infill if you want.
Printed with 0.12mm layer height. Adjust to taste.
Measurements are approximately:
Length: 43mm
Width: 25mm
Height: 9.7mm
Can be printed without supports.
Wall thickness (1.6mm) is made so it can be printed with a line width of 0.4mm. This way you should be able to print it without any infill if you want.
Printed with 0.12mm layer height. Adjust to taste.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
